Subscribe to:
Post Comments (Atom)
A blog by a "sucker" and a "loser" who served her country in the Navy.
If you're one of the Covidiots who believe that COVID-19 is "just the flu",
that the 2020 election was stolen, or
especially if you supported the 1/6/21 insurrection,
leave now.
Slava Ukraini!
European Union laws require you to give European Union visitors information about cookies used on your blog. In many cases, these laws also require you to obtain consent.You're here, you've consented. If you don't like it, go read some other goddamn blog. It's not as if you're paying me.
8 comments:
Aviation finally got with the times and tried acupuncture?
How did someone do that?
Leo, good question. Big CG shift after removing the engines, maybe?
The betting seems to be that the airplane was in the process of having parts removed for long-term storage. If that was the case, it was likely scrapped out.
Fell off the jackstand, who knows why...
"Hey, Boss, a funny thing happened last might in Hangar Four."
I bet the sound that made was epic.
"You'll just feel a little pressure..."
When you jack an aircraft for gear swings the manual will give you a minimum clearance under the wheels. The gear moves in an arc around the trunnion so as the gear retracts the outside tire at first descends before it starts to rise into the well.
If you haven't jacked it high enough as the gear retracts the outside tire will contact the hangar floor, lift the wing off the jack and move the airplane enough so that when the wing comes down the jack will not be under the jacking point. The jack will then punch a hole through the wing usually damaging the rear spar. The next thing that happens is the A&P in charge packs his toolbox, puts it in his truck and starts looking for a new job. I always make a point of measuring the clearance and adding an extra inch or two when doing gear swings.
For a visual demonstration go here
https://www.youtube.com/watch?v=E9QE6LNdP4Y
and start at the 3m15 mark. Watch the left outboard wheel as the gear swings.
Al_in_Ottawa
Post a Comment