The M65 was used in the "pocket revolver" class; revolvers with 3" or shorter barrels. For pocket guns and .22s, the pins are on sawhorses. It's really unusual to topple a pin on a sawhorse and have it not fall off, but it does happen. There are three pins for pocket guns, five for .22s (and four for single-action revolvers).
You don't need anything fancy to shoot a pin match. Standard production guns work just fine. It helps to have an extra magazine or a speedloader in case you don't clear the table with what's in the gun.
In the video that is embedded in the post, you may have noticed that there is a length of 2x4 standing on the table. That's used to ensure that everyone begins from a safe angle and direction. The board is free-standing; half of the time, it falls over.
Two of the shooters used Ruger Blackhawks that were chambered for .30 Carbine in the single-action portion. Those were impressively loud. .38s sounded like popguns in comparison.
Next time around in the match, I'll probably shoot magnums in the M27. Recoil isn't significant in that gun and the loads'll whack the pins a little harder.
No comments:
Post a Comment
House Rules #1, #2 and #6 apply to all comments. Rule #3 also applies to political comments.
In short, don't be a jackass. THIS MEANS YOU!
If you never see your comments posted, see Rule #7.
All comments must be on point and address either the points raised in the blog post or points raised by commenters in response.
Any comments that drift off onto other topics are subject to deletion.
(Please don't feed the trolls.)
中國詞不評論，冒抹除的風險。僅英語。
COMMENT MODERATION IS IN EFFECT UFN. This means that if you are an insulting dick, nobody will ever see it.