The first mod for the 22/45 was a Lam bushing. It took longer to read through the directions twice than it did to install.
Helps that I have a pin punch to push the hammer pin with, as well as a dead-blow hammer for knocking loose (and reinstalling) the bolt stop and the barrel assembly.
The Lam bushing allows removal of the magazine disconnect hardware. Empty magazines have to be pried out if the disconnect crap is left in. With it gone, empty magazines drop free, as they should on any decent semiauto. And the trigger feels less gritty and somewhat lighter.
$12 well spent, if you have a Mk.III or a Mk.III 22/45.
A blog by a "sucker" and a "loser" who served her country in the Navy.
If you're one of the Covidiots who believe that COVID-19 is "just the flu",
that the 2020 election was stolen, or
especially if you supported the 1/6/21 insurrection,
leave now.
Slava Ukraini!
Monday, March 31, 2014
1 comment:
House Rules #1, #2 and #6 apply to all comments. Rule #3 also applies to political comments.
In short, don't be a jackass. THIS MEANS YOU!
If you never see your comments posted, see Rule #7.
All comments must be on point and address either the points raised in the blog post or points raised by commenters in response.
Any comments that drift off onto other topics are subject to deletion.
(Please don't feed the trolls.)
中國詞不評論，冒抹除的風險。僅英語。
COMMENT MODERATION IS IN EFFECT UFN. This means that if you are an insulting dick, nobody will ever see it.
Thanks, just ordered. Been meaning to do something about the mag disconnect for a while--before the next time I disassemble mine, at least. Whoever thought it a good idea to require a mag and trigger pull while you point the gun in odd directions should have to be the backstop...Up isn't my idea of a safe direction.
ReplyDelete(If I remember correctly, MkII parts are still available from Ruger and can be used to bypass the mag "safety".)